Motorized Card Reader And Writer ISO Standard Compliant For IC Card Handling

Product Description

High Quality Motorized card reader and writer ISO standard compliant for IC card handling

OVERVEIW
 

It is the first dual shutter protection card reader in the world. The first shutter is mechanical with dust and foreign things prevention function, and the other one is for motor protection. The main body is composite plastic with high temperature, abrasion and aging resistance, and two sides of card movement channel are embedded with stainless steel metal. It makes product with advancement in strength and precision. Module installation structure is convenient for customers to maintain product. Elaborate design and part combination makes product with fresh appearance and its precision meets or overpass the same product all over the world. Excellent circuit design takes multiple protection functions into consideration. It is a card reading equipment that can read or write many types of cards, supporting 8 pieces SIM card operation.

PICTURE

 
PARAMETERS
 
 

 
 
SUBJECT
 
IC card Reading & Writing
SIM card operation
Motor shutter
Alert Lamp
Input voltage detection
Input voltage protection in negative direction
 
SPECIFICATIONS
 
Accordance with ISO7810 7811 standard card
EMV,7816 PBOC 3.0
S50,S70,ID card
8 SIM card ports
Magnetic signal, Optoelectronic signal and rear card insert
Allow or enabled card to insert
Prevent dust and foreign things
Card entry alert, power on alert, IC card power on alert
Multiple card stop position
have protection alert when voltage is above 13v or below11V
Not above 40V
 
NOTES
 
When connecting interface, please connect with communication interface first, then power interface. And then power on.
2) To make your product safe, the input voltage please not above 40V.
 
3) Please set BPS rate correct. EX-work set is 9600bps.
 
4) During operation, card insert direction should be correct
 
a) When inserting magnetic card, magnetic stripe should face down and insert on the right side. b) When inserting IC card, chip should face up. If insert from the front, the end close to chip
should be inserted into card reader first. If insert from the rear, the end away from chip should be inserted into card reader first.
c) When inserting RF card, directions are not considered. But it can only be operated at RF
 
position.
 
5) When there is card in the machine, error message will be given if inserting card again. And motor door will not open.
6) When shutting off power, power interface should be shut off first, then communication interface.
 
7) Power off during operation or other abnormal reason lead to card staying in the machine and cannot be taken out, please take out card by pulling belts manually.