RS232 Manual Insertion Casino Card Reader IC Card Reader Writer With ISO7816

Product Description

IC Chip RS232 Manual Insertion Casino Card Reader With ISO7816

Overview:

    RCR-2200  is a manual insertion type IC card reader/writer module, IC card in accordance with ISO 7816 and support T=0 protocol and T=1 protocol. It is a low-voltage, low-cost, and small card reader chip. It is a better choice for smart and portable, and it is easy-to-install and with high quality.

    Model list as following.

Feasures:

Compliant with ISO7816-1, 2, 3, 4

Read/write T=0/T=1

Read/write SLE4442, SLE4428 and other compatible products

Read/write AT24C01A/02/04/08/16/32/64/128/256, AT88SC10X and other compatible products

Use the new design IC card connector, reduce the destroy on cards

Electro circuit protect, preventing the wrong operation on cards. Prohibition read/write operation on cards when the power supply is not stable

Specification:

Application:

  Self-service terminal

  Gaming slot

  Recharging machine

  Automatic vending machine

  Payment terminals

Communication parameter:

• Interface Definition. PH2.0/4P

• RS-232 Interface Communication Parameter:

    Asynchronous, RS-232 level

    Start Bit, 1 bit; Data Bit, 8 bits; Stop Bit, 1 bit

    Baud Rate, 9600(default)/19200/38400/57600/115200 bps

IC card:

    IC card is short for integrated circuit card, which inserts an integrated circuit chip on a plastic card. The IC card is the same size as the magnetic card. Chips are usually composed of non-volatile memory (ROM, EPROM, E 2PROM), protective logic circuits, and even CPU(central processing unit).

Maintenance:

    There will be something dirty on IC card contact which will influence IC card reading and writing after using for a while. Therefore, we must make a certain maintenance for card reader. the specific procedure as below:

1) Using cleaning card to clean dirty things on IC contact.

2) Periodical maintenance: it needs to clean maintenance once when card in and out 20,000 times. (count once when card in and out.)

    Contact maintenance: it will cause IC card and contact touch error when there is dirty things on contact. It should clean the contact pin, the main method is that we use cleaning card with alcohol to clean card reader, make auto test IC card operation.

Notes:

1) Make sure power off in order not to damage the card reader when person maintains.

2) Keep card reader clean without any oil dirt.

3) IC card insertion direction: the chip of IC card upward, and insert card from the front.